New Connecting Rod, Separating
WARNING: This page is about a different car, the 2018 Audi Q3 Quattro, 2018 Audi Q3, 2017 Audi Q3 Quattro, and 2017 Audi Q3. However, it is still accessible from the selected car via links, so may be relevant.
A new connecting rod might not be separated all the way at the predetermined breaking point. If the connecting rod bearing cap cannot be removed by hand, proceed as follows:
-- Mark the cylinder where the connecting rod is allocated to, refer to -item 4- (OVERVIEW - PISTONS AND CONNECTING ROD).
-- Lightly clamp the connecting rod in a vise equipped with aluminum protective pads.
- Clamp the connecting rod lightly to prevent damaging it.
- Clamp the connecting rod below the dotted line.
-- Loosen both bolts -arrows- approximately five turns.
-- Carefully tap the connecting rod bearing cap with a plastic hammer in direction of -arrow- until it comes loose.