Sub-Assembly Bracket, Removing And Installing: Installing
WARNING: This page is about a different car, the 2018 Audi Q3 Quattro, 2018 Audi Q3, 2017 Audi Q3 Quattro, and 2017 Audi Q3. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
- Replace the bolts that were tightened with an additional turn after removing them.
- Replace the O-ring and seals after removing.
- Used coolant cannot be used again.
-- Coat the new O-rings -4- with coolant.
-- Insert the connection -2- into the coolant pump housing -3-.
-- Slide the sub-assembly bracket -1- onto the connection and then install and tighten the bolts.
-- Install the oil filter element and check the oil level. Refer to ENGINE OIL .
-- Install the generator. Refer to .
-- Install the A/C compressor. Refer to A/C Compressor, Removing And Installing .
-- Install the ribbed belt. Refer to RIBBED BELT, REMOVING AND INSTALLING .
-- Fill with coolant. Refer to COOLANT, DRAINING AND FILLING .