Oil Pump, Removing And Installing: Installing
WARNING: This page is about a different car, the 2018 Audi Q3 Quattro, 2018 Audi Q3, 2017 Audi Q3 Quattro, and 2017 Audi Q3. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
- Replace the oil baffle after removal.
- Replace the bolts that were tightened with an additional turn after removing them.
-- Make sure both alignment bushings for centering the oil pump are present.
-- Guide the oil pump chain sprocket into the drive chain and install the oil pump.
CAUTION:
- Ensure the tension spring wire clip is engaged correctly on the locating tab of the oil pan upper section.
-- Pull the wire clip of the chain tensioner tension spring with the : T10118 in the direction of -arrow- and remove the : T40265 .
-- Insert the new oil baffle and secure it.
-- Install the oil pan lower section. Refer to OIL PAN LOWER SECTION, REMOVING AND INSTALLING .
-- Fill the engine oil and check the oil level. Refer to ENGINE OIL .