Oil Separator, Removing And Installing. On Cylinder Block: Removing

WARNING: This page is about a different car, the 2018 Audi Q3 Quattro, 2018 Audi Q3, 2017 Audi Q3 Quattro, and 2017 Audi Q3. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the noise insulation. Refer to Noise Insulation, Removing And Installing

-- If installed, remove the noise insulation frame. .

Oil Separator, Version 1:

Courtesy of AUDI OF AMERICA, LLC

-- Press the release buttons, remove the crankcase ventilation hose -arrow- and lay it aside.

-- Remove the bolts -1 through 8- and remove the oil separator.

Oil Separator, Version 2:

Courtesy of AUDI OF AMERICA, LLC

-- If installed, remove the bolt -2- and move the After-Run Coolant Pump -V51- to the side.

-- Remove the bolts -1 through 9- and remove the oil separator.

Courtesy of AUDI OF AMERICA, LLC

TIP:

To prevent dirt from entering the lubrication system, seal the opening with a clean cloth.