Coolant Pump, Removing And Installing: Installing

WARNING: This page is about a different car, the 2018 Audi Q3 Quattro, 2018 Audi Q3, 2017 Audi Q3 Quattro, and 2017 Audi Q3. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and note the following:

Replace the seal and O-ring after removal.

-- Coat the O-rings -4- with coolant. Refer to Parts information for the coolant.

-- Make sure that both centering pins are installed in the cylinder block if necessary insert.

-- Install the connection piece -2- into the engine oil cooler -1-.

-- Push the coolant pump -3- onto the connection piece and onto the centering pins in the cylinder block.

-- Tighten the coolant pump bolts. Refer to Figure.

-- After installing a new coolant pump, remove the protective cap -arrow- from the drive wheel.

-- Install the coolant pump toothed belt. Refer to COOLANT PUMP TOOTHED BELT, REMOVING AND INSTALLING .

There are additional procedures depending on the model. Refer to COOLANT PUMP, REMOVING AND INSTALLING .