Overview - Flywheel
WARNING: This page is about a different car, the 2018 Audi Q3 Quattro, 2018 Audi Q3, 2017 Audi Q3 Quattro, and 2017 Audi Q3. However, it is still accessible from the selected car via links, so may be relevant.
- Dual Mass Flywheel
- Allocation. Refer to the Parts Information .
- Removing and installing. Refer to FLYWHEEL, REMOVING AND INSTALLING .
- Only possible to install in one position - holes are offset -
- Alignment Sleeve
- Transmission Side Sealing Flange
- Always replace after removing.
- With gasket
- Do not apply oil to the seal.
- Before installing, remove oil residue from crankshaft journal with a clean cloth.
- Removing and installing. Refer to SEALING FLANGE, REMOVING AND INSTALLING, TRANSMISSION SIDE .
- Cylinder Block
- Bolt
- Intermediate Plate
- The illustration does not show the version in the vehicle.
- Be careful not to damage or bend when installing
- Installing. Refer to Fig 4.
- Alignment Sleeve
- Bolt
- 60 Nm + 90°
- Always replace after removing.
Transmission Side Sealing Flange with Six Bolts - Tightening Specifications and Sequence.
- Replace the bolts that were tightened with an additional turn after removing them.
-- Tighten the bolts in the steps shown in the sequence:
| Step | Bolts | Tightening Specifications |
|---|---|---|
| 1. | -1 to 6- | Install by hand all the way |
| 2. | -1 to 6- | Aluminum bolts: 4 Nm Steel bolts: 9 Nm |
| 3. | -1 to 6- | Aluminum bolts: 45° additional turn |
TIP:
Only six bolts are installed, two bolt openings remain open.
Transmission Side Sealing Flange with Eight Bolts - Tightening Specifications and Sequence
-- Tighten the bolts in the steps shown in the sequence:
| Step | Bolts | Tightening Specifications |
|---|---|---|
| 1. | -1 to 8- | Install by hand all the way |
| 2. | -1 to 8- | 9 Nm |
Intermediate plate, installing
-- Hang the intermediate plate on the sealing flange -upper arrow- and slide it on the alignment sleeves -lower arrows-.