Overview - Drive Plate
WARNING: This page is about a different car, the 2018 Audi Q3 Quattro, 2018 Audi Q3, 2017 Audi Q3 Quattro, and 2017 Audi Q3. However, it is still accessible from the selected car via links, so may be relevant.
- Cylinder Block
- Transmission Side Sealing Flange
- Always replace after removing.
- With gasket
- Do not apply oil to the seal.
- Before installing, remove oil residue from crankshaft journal with a clean cloth.
- Removing and installing. Refer to SEALING FLANGE, REMOVING AND INSTALLING, TRANSMISSION SIDE .
- Bolt
- Tightening sequence. Refer to Figure.
- Drive Plate
- Allocation. Refer to the Parts Information .
- Drive plate installation position: >>collar<< faces the engine
- Removing and installing. Refer to DRIVE PLATE, REMOVING AND INSTALLING .
- Bolt
- 60 Nm + 90°
- Always replace after removing.
- Not Installed
- Intermediate Plate
- The illustration does not show the version in the vehicle.
- Be careful not to damage or bend when installing
- Installing. Refer to Figure.
- Alignment Sleeve