Drive Plate, Removing And Installing, Dual-Clutch Transmission: Installing
WARNING: This page is about a different car, the 2018 Audi Q3 Quattro, 2018 Audi Q3, 2017 Audi Q3 Quattro, and 2017 Audi Q3. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
- Replace the bolts that were tightened with an additional turn after removing them.
-- Pay attention to the alignment pin when installing the drive plate.
-- Turn the :10-201 to tighten the bolts.