Ribbed Belt TENSIONER, Removing And Installing, Version 1: Installing
WARNING: This page is about a different car, the 2018 Audi Q3 Quattro, 2018 Audi Q3, 2017 Audi Q3 Quattro, and 2017 Audi Q3. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
-- Insert the ribbed belt tensioner -2- into the sub-assembly bracket -4- and tighten the bolt -6-.
- Note the installation position of the support -3- : Insert the tabs on the support into the hole in the sub-assembly bracket.
- Note the centering bracket -5-.
-- Install the ribbed belt. Refer to RIBBED BELT, REMOVING AND INSTALLING .
There are additional procedures depending on the model. Refer to RIBBED BELT TENSIONER, REMOVING AND INSTALLING .