Sensor Wheel, Removing And Installing: Installing
WARNING: This page is about a different car, the 2018 Audi Q3 Quattro, 2018 Audi Q3, 2017 Audi Q3 Quattro, and 2017 Audi Q3. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
-- Always replace the sensor wheel -2- each time the bolts -1- are loosened.
TIP:
After tightening a second time, the attachment point of the countersunk bolts in the sensor wheel is so deformed that the bolt heads are at the crankshaft -3- -arrows- and the sensor wheel is loose under the bolts.
- Installation of sensor wheel is only possible in one position - the bores are offset.
-- If the sensor wheel is replaced perform the adaptation. Refer to Vehicle Diagnostic Tester.