Crankshaft Needle Bearing, Replacing: Installing
WARNING: This page is about a different car, the 2018 Audi Q3 Quattro, 2018 Audi Q3, 2017 Audi Q3 Quattro, and 2017 Audi Q3. However, it is still accessible from the selected car via links, so may be relevant.
-- Clean the bearing seat in the crankshaft and apply a thin coat of grease.
-- Drive the needle bearing into the crankshaft up to the installation depth using the :VW207C .
- If the needle bearing is unintentionally pushed in to deeply, it must be replaced, because it will be damaged when it is removed again.