Balance Shaft, Removing And Installing, Intake Side: Removing
WARNING: This page is about a different car, the 2018 Audi Q3 Quattro, 2018 Audi Q3, 2017 Audi Q3 Quattro, and 2017 Audi Q3. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the coolant pump toothed belt. Refer to COOLANT PUMP TOOTHED BELT, REMOVING AND INSTALLING .
-- Remove the balance shaft drive chain. Refer to BALANCE SHAFT DRIVE CHAIN, REMOVING AND INSTALLING .
-- Remove the bolt -2- and then remove the drive wheel -1- for the coolant pump toothed belt.
-- Remove the intermediate sprocket -1-.
-- Remove the mounting pin -1-.
-- Remove the bolt -2- on the intake camshaft balance shaft.
-- Insert the : T10394/1 from the :T10394 and turn upward in the direction of the arrow.
-- Insert the :T10394 and push the sliding sleeve in the direction of -arrow-.
-- Install the :T10055 into the :T10394 and remove the balance shaft in the direction of -arrow-.