Engine Temperature Control Actuator -N493-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2018 Audi Q3 Quattro, 2018 Audi Q3, 2017 Audi Q3 Quattro, and 2017 Audi Q3. However, it is still accessible from the selected car via links, so may be relevant.

Depending on the model, preliminary work may be required. ; Engine Temperature Control Actuator -N493-, Removing and Installing.

-- Remove the Throttle Valve Control Module -J338-. Refer to Throttle Valve Control Module -J338-, REMOVING AND INSTALLING .

-- Remove the coolant pump. Refer to COOLANT PUMP, REMOVING AND INSTALLING .

-- If still connected, pry up the clips -1- and remove the coolant hoses.

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -1- for the Engine Temperature Control Actuator -N493-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -1 to 5-.

Fig 1: Engine Temperature Control Actuator Tightening Sequence

Courtesy of AUDI OF AMERICA, LLC

NOTE: For engine temperature control actuator, tightening and loosening sequence is the same, -1 to 5-.

-- Remove the Engine Temperature Control Actuator -N493- from the centering pin and disconnect it from the engine oil cooler.