Engine Temperature Control Actuator -N493-, REMOVING AND INSTALLING: Installing

WARNING: This page is about a different car, the 2018 Audi Q3 Quattro, 2018 Audi Q3, 2017 Audi Q3 Quattro, and 2017 Audi Q3. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of AUDI OF AMERICA, LLC

Install in reverse order of removal and note the following:

Replace the seals and O-ring after removal.

-- Coat the new O-rings -4- with coolant.

-- Make sure that both centering pins are installed in the cylinder block if necessary insert.

-- Install the connection piece -2- into the engine oil cooler -1-.

-- Push the Engine Temperature Control Actuator -N493- -item 3- into the connection piece and onto the centering pins in the cylinder block.

-- Install the coolant pump. Refer to COOLANT PUMP, REMOVING AND INSTALLING .

-- Remove the Throttle Valve Control Module -J338-. Refer to Throttle Valve Control Module -J338-, REMOVING AND INSTALLING .

Additional procedures depending on the model. ; Engine Temperature Control Actuator -N493- Removing and Installing.

-- Perform the adaptation after replacing using the Vehicle Diagnostic Tester.