Coolant Pump, Removing And Installing: Removing

WARNING: This page is about a different car, the 2018 Audi Q3 Quattro, 2018 Audi Q3, 2017 Audi Q3 Quattro, and 2017 Audi Q3. However, it is still accessible from the selected car via links, so may be relevant.

Depending on the model, preliminary work may be required. .

-- Loosen the bolts -1 through 4-, and remove the coolant pump from the Engine Temperature Control Actuator -N493-.

NOTE: For the coolant pump tightening and loosening sequence is the same, -1 to 4-.

Fig 1: Coolant Pump Tightening Sequence

Courtesy of AUDI OF AMERICA, LLC

-- Remove the toothed belt from the coolant pump.

NOTE:

If the coolant pump cannot be removed as described remove the Throttle Valve Control Module -J338-. Refer to Throttle Valve Control Module -J338-, REMOVING AND INSTALLING .