Overview - Cover And Cushion, Backrest Without A Pass-Through

NOTE:

A right 2/3 rear seat backrest is shown in the assembly overview. The left 1/3 rear seat backrest is identical.

Fig 1: Exploded View Of Cover And Cushion (Backrest Without A Pass-Through)

Courtesy of AUDI OF AMERICA, LLC

Backrest Cover
- Backrest cover and cushion, removing and installing. Refer to COVER AND CUSHION, REMOVING AND INSTALLING, BACKREST .
- Backrest cover and cushion, separating and assembling. Refer to COVER AND CUSHION, SEPARATING, BACKREST .
- Allocation. Refer to the parts information .
- Make sure there are no folds after installing
Wire
- Embedded in the foam of the backrest cushion
- For attachment of backrest cover to backrest cushion
Contour Strip
- Sewn into backrest cover
- For attachment of backrest cover to backrest cushion
Upholstery Clip
- For attachment of backrest cover to backrest cushion
- Replace
- Install at the same location with Upholstery Clip Pliers:VAG1634 .
Backrest Frame
- Removing and installing. Refer to COVER AND CUSHION, REMOVING AND INSTALLING, BACKREST .
Backrest Cushion
- Backrest cover and cushion, removing and installing. Refer to COVER AND CUSHION, REMOVING AND INSTALLING, BACKREST .
- Backrest cover and cushion, separating and assembling. Refer to COVER AND CUSHION, SEPARATING, BACKREST .
- Allocation. Refer to the parts information .
Clamping Strip
- Sewn into backrest cover
- For attaching the backrest cover on the backrest frame