Bearing Bracket, Removing And Installing, Engine With Two Camshaft Adjusters: Installing

Courtesy of AUDI OF AMERICA, LLC

-- Install the bolts -arrows- and tighten them. Tightening specification, refer to -item  4- Bolt (OVERVIEW - CYLINDER HEAD).

-- Coat the holes -arrows- with engine oil.

Courtesy of AUDI OF AMERICA, LLC

-- Check if the adapter sleeve -1- is installed.

• If a new bearing bracket -3- with adapter sleeve -4- should be installed, it must be checked before installing the bearing bracket in the hole -arrow- in the cylinder head -1-.

  Courtesy of AUDI OF AMERICA, LLC

• If the hole -arrow- is not designed for using the adapter sleeve -4- the adapter sleeve must be removed from the bearing bracket. For this hole the short bolt -2- should be used. Bolt. Refer to the parts information .

• Carefully connect the bearing bracket without tilting - risk of damage.

  Courtesy of AUDI OF AMERICA, LLC

-- Mount the bearing bracket and the bolts -arrows- hand-tight.

-- Remove the : T40267  .

-- Tighten the bearing bracket bolts. Refer to Figure.

Installation is performed in reverse order of removal, noting the following:

-- Install the upper timing chain cover. Refer to TIMING CHAIN COVER, REMOVING AND INSTALLING, ENGINE WITH TWO CAMSHAFT ADJUSTERS .

-- After performing work on the chain drive the adaptation value in the engine control module must be adapted. To do so, turn on the ignition and select the following menu items on the Vehicle Diagnostic Tester:

• 01 - Engine Electronics 
• Guided Functions 
• 01 - Adaptation after repair work on the chain drive