Bearing Bracket, Removing And Installing, Engine With One Camshaft Adjuster: Installing
WARNING: This page is about a different car, the 2018 Audi Q3 Quattro, 2018 Audi Q3, 2017 Audi Q3 Quattro, and 2017 Audi Q3. However, it is still accessible from the selected car via links, so may be relevant.
-- Install the bolts -arrows- and tighten them. Tightening specification, refer to -item 4- Bolt (OVERVIEW - CYLINDER HEAD).
-- Lubricate the hole -arrow- with engine oil.
- If a new bearing bracket -3- with adapter sleeve -4- should be installed, it must be checked before installing the bearing bracket in the hole -arrow- in the cylinder head -1-.
- If the hole -arrow- is not designed for using the adapter sleeve -4- the adapter sleeve must be removed from the bearing bracket. For this hole the short bolt -2- should be used. Bolt. Refer to the parts information .
-- Mount the bearing bracket and the bolts -arrows- hand-tight.
-- Remove the : T40267 .
-- Tighten the bolts -arrows-. Refer to Figure.
Installation is performed in reverse order of removal, noting the following:
-- Install the upper timing chain cover. Refer to TIMING CHAIN COVER, REMOVING AND INSTALLING, ENGINE WITH ONE CAMSHAFT ADJUSTER .
-- After performing work on the chain drive the adaptation value in the engine control module must be adapted. To do so, turn on the ignition and select the following menu items on the Vehicle Diagnostic Tester:
- 01 - Engine Electronics
- Guided Functions
- 01 - Adaptation after repair work on the chain drive