Overview - Ignition System
WARNING: This page is about a different car, the 2018 Audi Q3 Quattro, 2018 Audi Q3, 2017 Audi Q3 Quattro, and 2017 Audi Q3. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 20 Nm
- The tightening specifications affects function of the knock sensor
- Knock Sensor 1 -G61-
- Versions: depending on the version the Knock Sensor 2 -G66- is additionally installed. Refer to appropriate SYSTEM WIRING DIAGRAM(S) information.
- Removing and installing. Refer to Knock Sensor 1 -G61-, REMOVING AND INSTALLING .
- Bolt
- 9 Nm
- Camshaft Position Sensor -G40-
- Removing and installing. Refer to CAMSHAFT POSITION SENSOR, REMOVING AND INSTALLING .
- O-ring
- Always replace after removing.
- Ignition Coil with Power Output Stage
- Ignition Coil 1 with Power Output Stage -N70-
- Ignition Coil 2 with Power Output Stage -N127-
- Ignition Coil 3 with Power Output Stage -N291-
- Ignition Coil 4 with Power Output Stage -N292-
- Removing and installing. Refer to IGNITION COILS WITH POWER OUTPUT STAGES, REMOVING AND INSTALLING .
- Spark Plug
- 30 Nm
- O-ring
- Always replace after removing.
- Engine Speed Sensor -G28-
- Removing and installing. Refer to Engine Speed Sensor -G28-, REMOVING AND INSTALLING .
- Bolt
- 4.5 Nm