Drive Plate, Installing
-- First position the drive plate without the washer -A-.
-- Insert the used bolts -3- and tighten them to 30 Nm.
-- Check the dimension between the drive plate and the cylinder block in three locations and calculate the average.
NOTE:
This Is Measured Through The Hole In The Drive Plate To The Machined Surface Of The Cylinder Block. When Measuring On The Intermediate Plate, Take The Thickness Of The Plate Into Consideration.
- Specified value measured without intermediate plate: 19.5 to 21.1 mm
- Specified value measured with intermediate plate: 18.8 to 20.4 mm