Balance Shaft Sealing Ring, Replacing, Intake Side: Procedure

-- Remove the toothed belt from the coolant pump. Refer to COOLANT PUMP TOOTHED BELT, REMOVING AND INSTALLING .

-- Remove the bolt -2- and then remove the drive gear -1- for the coolant pump toothed belt.

Courtesy of AUDI OF AMERICA, LLC

-- Firmly press a screwdriver -1- on the seal surface -2- in the direction of -arrow B-.

Courtesy of AUDI OF AMERICA, LLC

-- Pry out the sealing ring in the direction of -arrow A-.

-- Clean the running and sealing surface.

-- Coat the sealing surface of the balance shaft -2- with transmission oil.

Courtesy of AUDI OF AMERICA, LLC

-- Push the seal -1- onto the balance shaft.

• "Luftseite" or ("Outside") -arrow- must be readable from the outside.

-- Mount the :T10353  on the shaft seal -1- and then tighten it all the way into the cylinder block with the screw -2-. Be careful not to tilt the shaft seal when doing this.

Courtesy of AUDI OF AMERICA, LLC

-- Install the toothed belt on the coolant pump. Refer to COOLANT PUMP TOOTHED BELT, REMOVING AND INSTALLING .

-- Fill with coolant. Refer to COOLANT, DRAINING AND FILLING .