Overview - Driveshaft, AUDI RS Q3
NOTE:
Do not perform any service work on the driveshaft.
- Transmission with Bevel Gear
- Bolt
- 60 Nm
- For attaching the driveshaft to the bevel box
- Driveshaft
- Cannot be separated at the joint -arrow-
- Removing and installing. Refer to DRIVESHAFT, REMOVING AND INSTALLING, AUDI RS Q3 .
- Bolt
- 25 Nm
- Intermediate Bearing
- Align free of tension
- Bolt
- 50 Nm and 90°
- Always replace
- For the rear flexible disc on the driveshaft
- Bolt
- 60 Nm
- For flexible disc to final drive
- Flexible Disc with Vibration Damper
- Heat shield faces the driveshaft
- Removing and installing. Refer to REAR FLEXIBLE DISC, REMOVING AND INSTALLING .
- Rear Final Drive
- Removing and installing. Refer to REAR FINAL DRIVE, REMOVING AND INSTALLING, AUDI Q3 .