High-Performance All Wheel Drive Clutch Oil, Filling
Procedure
-- Place the : VAS6208 under the final drive.
-- To fill, use the : VAS6291A .
-- Remove the oil filler plug -2- for the High-Performance All Wheel Drive Clutch Oil.
-- Disconnect the adapter -A- and elbow -B-.
-- Install the adapter -A- all the way.
Audi A1 quattro
-- Attach the following adapters according to the sequence:
- Pressurized Gearbox Oil Filler - Adapter 9: VAS6617/9
- Pressurized Gearbox Oil Filler - Adapter 3: VAS6617/3
- Pressurized Gearbox Oil Filler - Adapter 2: VAS6617/2
- Oil Filler - Adapter: VAS6291A/4
Continuation for All Vehicles
-- Lock the elbow -B- with the adapter -A-.
-- Route the Charging Device hose over the drive axle.
- The hose must not sag. It must enter above left rear wheel on vehicle.
-- Lower the vehicle.
-- Pay attention to that the valve -arrow- is closed.
-- Attach the oil container -A- to the : VAS6291A .
-- Open the valve -arrow- and hold the oil container as shown.
The all wheel drive clutch is now filled.
-- Raise the vehicle.
-- If oil escapes, place an oil container under the all wheel drive clutch (for example, on a workshop cart).
Overflowing oil now runs back into the oil container.
-- When the oil stops flowing, remove the : VAS6291A .
- The all wheel drive clutch is not filled up to the lower edge of the oil filler hole.
-- Install a new oil filler plug -2-.
-- Finally, check the oil level in the all wheel drive clutch. Refer to ALL WHEEL DRIVE CLUTCH OIL LEVEL, CHECKING .