LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2015 >> A6 Premium Plus >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Exterior Body Panels (Hood, Lids) >> 55 Hood, Lids >> Rear Lid, Sedan >> Rear Lid Hinge, Removing And Installing >> Notes

Rear Lid Hinge, Removing And Installing: Notes

NOTE:

Remove and install the left and right hinges one after the other when replacing the hinges on both sides.

Mark the position of the hinges on the rear lid before removing them.

Use the markings on the rear lid hinge when adjusting the hinge lengthwise.

Fig 1: Removing/Installing Rear Lid Hinge
GWWA55-10765Courtesy of AUDI OF AMERICA, LLC
  1. Rear Lid Hinge
    NOTE:

    Have a second technician hold the rear lid so that it cannot fall down.

    • The luggage compartment side trim is removed. Refer to Description and Operation .

      -- Remove the nuts -3- from the rear lid first.

      -- Remove the bolts -2- from the side panel and remove the hinge.

      -- Align the with the markings when installing and then tighten the bolts and nuts to the tightening specification.

      -- Check the gap dimensions. Refer to Gap Dimensions .

  2. Bolt
    • 21 Nm
  3. Nut
    • 21 Nm
  4. Bracket
scientia non olet · About LEMON Manuals