Wheel Bearing Housing Bonded Rubber Bushing, Replacing, AWD Vehicles And E-Tron: Removing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove wheel bearing housing. Refer to WHEEL BEARING HOUSING, REMOVING AND INSTALLING, FWD VEHICLES, EXCEPT E-TRON .
- In order to remove the front rubber bonded bushing, the :T40184/2 -3- must be mounted on the front rubber bonded bushing in such a way so that the lugs -2- fit into the grooves -4-.
-- Place the tools on the front bonded rubber bushing and the wheel bearing housing as illustrated.
NOTE:
When mounting the wheel bearing housing onto the :T40184/1 be careful not to damage or push the rubber grommet on the rear rubber bonded bushing.
- :VW411
- :T40184/2
- Wheel bearing housing
- :T40184/1 . The side with the groove must face the wheel bearing housing. On a bonded rubber bushing with a "positioning tab", this is in the groove on the :T40184/1 .
-- Press out the front rubber bonded bushing.