Applies to A Hydraulic Bonded Rubber Bushing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Pry the plastic stop -1- upward and off the bonded rubber bushing.
Applies to All
-- Pry the stop plate -1- off the bonded rubber bushing alternating from side to side.
-- Mark the installed position of the hydraulic bonded rubber bushing on the subframe -arrows- with a felt-tip pen for installation later.
-- If necessary, the support -arrow- with the >>small<< interior diameter must be removed from the :VAS6178 and the :T10205/13 for it must be installed.
-- Place the tools on the front bonded rubber bushing as shown in the illustration.
- :T10263/5
- :T40185/5 . The opening faces the rubber bonded bushing.
- Subframe
- :T40185/6 . The conical side must face upward and the ribs must fit into the openings in the rubber bonded bushing.
- :T40033/3
- :T10205/4
- :VAS6178
- :T10263/5
- :T10263/4 The spindle pins face downward.
WARNING:
- Hold the :VAS6178 firmly while pressing out.
- Bonded rubber bushing loosens >>abruptly<<. There is the risk of injuries by tools and bonded rubber bushing coming off!