Fuel Injector Seals, Removing And Installing
WARNING: This page is about a different car, the 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Injector/Combustion Chamber Seal Tool Set :T10133C
- Adapter :T10133/2
- Slide Hammer :T10133/3
- Socket - 24mm :T10361A
- Socket - 24mm :T10361
- Puller - Shaft Seal :T40195
-- Remove the fuel injector in question. Refer to FUEL INJECTORS, REMOVING AND INSTALLING .
-- Install the :T40195 into the seal -1-.
-- Attach the :T10133/3 to the seal puller with the :T10133/2 as shown in the illustration and remove it by tapping it upward.
-- Install the new fuel injector seal all the way with the :T10361 and the short extension -1-.