Rear Lid Trim Molding, Replacing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Hot Air Blower :VAG1416
- Roller :3356
- Cleaning Solution :D 009 401 04
-- Warm up and gradually remove the adhesive surfaces from the inside of the rear lid using the :VAG1416 .
Remove the adhesive residue from the rear lid if necessary.
-- Clean the adhesive surfaces on the vehicle body with Cleaning Solution -D 009 401 04-.
--
-- When installing, apply centered to the rear lid with contour precision.
-- Remove the protective film by the removal tabs between the rear lid and the trim molding gradually and press on by hand.
-- Press the trim molding with the :3356 after successful application.