After-Run Coolant Pump -V51-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2012 Audi Q5, 2011 Audi Q5, 2010 Audi Q5, and 2009 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Noise Insulation

Courtesy of AUDI OF AMERICA, LLC

WARNING:

Risk of scalding due to hot steam and hot coolant.

The coolant system is under pressure when the engine is warm.
Reduce pressure by covering coolant reservoir cap with a cloth and carefully opening.

-- Open the coolant reservoir cap.

-- Remove the front noise insulation -1-, refer to FRONT NOISE INSULATION .

-- Remove bolt -1- and disconnect harness connector -2-.

Fig 2: Identifying After-Run Coolant Pump (If Equipped)

Courtesy of AUDI OF AMERICA, LLC

-- Place the Shop Crane - Drip Tray VAS6208 under engine.

-- Open the hose clamps -arrows- and remove the After-Run Coolant Pump -V51- from the coolant hoses.