Overview - Oil Pan/Oil Pump
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
If large quantities of metal particles or abraded material are detected during engine repairs, it may mean the crankshaft or rod bearings are damaged. To prevent damage, perform the following steps after completing the repair: carefully clean the oil channels and replace the oil spray jets, the oil cooler and the oil filter.
Oil injector jet for piston cooling, refer to Fig 1.
- Nut
- 9 Nm
- Oil Level Thermal Sensor -G266-
- Removing and installing, refer to Oil Level Thermal Sensor -G266-, REMOVING AND INSTALLING .
- Seal
- Replace
- Oil Pan Lower Section
- Removing and installing, refer to OIL PAN LOWER SECTION, REMOVING AND INSTALLING .
- Bolt
- 9 Nm
- Lower Oil Baffle
- Bolt
- Replace
- Tightening specification and sequence, refer to Fig 4.
- Oil Pan Upper Section
- Removing and installing, refer to OIL PAN UPPER SECTION, REMOVING AND INSTALLING .
- Alignment Sleeve
- Quantity: 2
- O-Ring
- Replace
- Insert into guide frame
- Bolt
- 3 Nm +90°
- Replace
- Install with locking compound, refer to parts.
- Upper Oil Baffle
- Seal
- Insert into guide frame
- Replace
- Seal
- Replace
- Bolt
- 3 Nm +90°
- Replace
- Engine Oil Cooler
- With oil cooler bypass valve
- See note, refer to OVERVIEW - OIL PAN/OIL PUMP - "NOTE: ".
- Removing and installing, refer to ENGINE OIL COOLER, REMOVING AND INSTALLING .
- Bolt
- 9 Nm
- Input Shaft
- For the oil pump
- Pressure Spring
- Sleeve
- Quantity: 2
- Mounting Bracket
- Bolt
- 9 Nm
- Chain Sprocket
- For the oil pump
- Can only be placed onto drive axle in one position
- Bolt
- 30 Nm +90°
- Replace
- For loosening and tightening, counterhold on the chain sprocket with a Wrench - Pin Type 3212
- O-Ring
- Replace
- Seal
- Replace
- O-Ring
- Replace
- Oil Pump
- Do not disassemble
- Removing and installing, refer to OIL PUMP, REMOVING AND INSTALLING .
- Bolt
- 20 Nm
- Bolt
- Replace
- Tightening specification and sequence, refer to Fig 3.
- Seal
- Replace
- Oil Drain Plug
- 30 Nm
NOTE:
Replace the bolts that were tightened with an additional turn.
-- Tighten bolts in two stages as follows:
| Step | Tightening Specification/Additional Turn |
|---|---|
| 1. | 8 Nm diagonally |
| 2. | In a diagonal sequence, turn an additional 90° |
-- Then tighten the bolts -1 through 6- in a diagonal sequence in stages to 20 Nm: