Mounting Bracket, With Automatic Transmission: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Audi S4, 2013 Audi A4, 2012 Audi S4, 2012 Audi A4, and 2011 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

If possible, leave the brake pedal stop installed; it could break the mount for the brake lamp sensor if the brake pedal is released too quickly.

Make sure the wall seal is seated properly before inserting the mounting bracket.

-- Install the mounting bracket into the guides in the vehicle.

-- Install the nuts on the mounting bracket guides and secure it.

-- Install the bolts from the brake booster -1- to the mounting bracket and tighten them.

Fig 1: Brake Booster Bolts, Brake Lines & Brake Master Cylinder Bolts

Courtesy of AUDI OF AMERICA, LLC

NOTE:

First install the bolts from the brake booster to the mounting bracket and tighten them.

Fig 2: Overview Of Brake Pedal Components

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the nuts -16- on the mounting bracket guides.

-- Connect the electrical connector to the gas pedal module.

Clip the brake pedal to the brake booster.

-- Hold the push rod ball head in front of the mount and push the brake pedal toward the brake booster, so that the ball head clicks into place.

WARNING:

If possible, leave the brake pedal stop installed; it could break the mount for the brake lamp sensor if the brake pedal is released too quickly.

-- Install the brake lamp sensor, refer to BRAKE LAMP SENSOR .

-- Push the steering column -1- on the steering shaft -3-.

Fig 3: Identifying Steering Intermediate Shaft

Courtesy of AUDI OF AMERICA, LLC

-- Mount the steering column onto the central tube and install the bolts.

NOTE:

Note that the bolts have different lengths.

-- Tighten the bolts -1 and 2 - diagonally to 20 Nm.

Fig 4: Identifying Steering Column Bolts

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Install the bolts -1 and 2- with a pawl with a 3/8" drive and socket and extension.

-- Tighten the bolts to 20 Nm with VAG 1331 and VAS 5122 with extension.

-- Mount the upper trim gap cover for for the steering column switch module (SMLS).

-- Install the cable guides on the steering column.

-- Tighten the bolt on the steering shaft -2- to 20 Nm.

Fig 5: Identifying Steering Intermediate Shaft

Courtesy of AUDI OF AMERICA, LLC

-- Install and tighten the lower bolts -1 through 4- for the steering column and mounting bracket to 20 Nm.

Fig 6: Identifying Lower Steering Column Bolts

Courtesy of AUDI OF AMERICA, LLC

-- Install the footwell vents -A-B-.

Fig 7: Identifying Footwell Vents

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the footwell vent screw -A-.

-- Connect the electrical connector to the footwell vent -C-.

-- Install the driver side cover -1 to 3-.

Fig 8: Identifying Driver Side Instrument Panel Cover

Courtesy of AUDI OF AMERICA, LLC

-- Install the cover -2- over the brake fluid reservoir.

Fig 9: Identifying Brake Master Cylinder Components

Courtesy of AUDI OF AMERICA, LLC

The cover -2- is not installed on all vehicle models.

-- Install the plenum chamber bulkhead, refer to PLENUM CHAMBER COVER, REMOVING AND INSTALLING .

-- Install the tower brace, refer to TOWER BRACE, REMOVING AND INSTALLING .