Brake Pedal, With Automatic Transmission: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Audi S4, 2013 Audi A4, 2012 Audi S4, 2012 Audi A4, and 2011 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Overview Of Brake Pedal Components

Courtesy of AUDI OF AMERICA, LLC

NOTE:

If possible, leave the brake pedal stop -17- installed; it could break the mount for the brake lamp sensor -10- if the brake pedal is released too quickly.

-- Slide the left retainer -12- onto the pins.

-- Slide the pins from left to right through the axle in the brake pedal.

-- Secure the pins with the right retainer -5-.

NOTE:

The pins must be secured with the securing clips -5 and 12- on both sides.

Fig 2: Overview Of Brake Pedal Components

Courtesy of AUDI OF AMERICA, LLC

-- Install and tighten the bolt -11-.

Clip the brake pedal to the brake booster.

-- Hold the push rod ball head in front of the mount and push the brake pedal toward the brake booster, so that the ball head clicks into place.

-- Install the brake lamp sensor, refer to BRAKE LAMP SENSOR .

-- Install the footwell vents -A-B-.

Fig 3: Identifying Footwell Vents

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the footwell vent screw -A-.

-- Connect the electrical connector to the footwell vent -C-.

-- Install the driver side instrument panel cover -1 to 3-.

Fig 4: Identifying Driver Side Instrument Panel Cover

Courtesy of AUDI OF AMERICA, LLC