Brake Booster Plunger Mount: Installing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Audi S4, 2013 Audi A4, 2012 Audi S4, 2012 Audi A4, and 2011 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
-- Insert the brake booster mount and ball socket in the brake pedal.
The mount must engage audibly.
Clip the brake pedal to the brake booster.
-- Hold the push rod ball head in front of the mount and push the brake pedal toward the brake booster, so that the ball head clicks into place.
-- Install the brake lamp sensor, refer to BRAKE LAMP SENSOR .
-- Install the footwell vents -A-B-.
-- Tighten the footwell vent screw -A-.
-- Connect the electrical connector to the footwell vent -C-.
-- Install the driver side instrument panel cover -1 to 3-.