Brake Booster Pressure Sensor -G294-: Removing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Audi S4, 2013 Audi A4, 2012 Audi S4, 2012 Audi A4, and 2011 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the plenum chamber cover, refer to PLENUM CHAMBER COVER, REMOVING AND INSTALLING .
NOTE:
The brake booster pressure sensor -- is located in the plenum chamber near the brake booster.
-- Disconnect electrical connector -1-.
-- Remove pressure sensor in -direction of arrow-.
NOTE:
The pressure sensor is secured with clips.
-- Release clips with pliers -1-.
-- Carefully pry the brake booster pressure sensor -- off.