Overview - Transmission Drain And Inspection Plug For Transmission Fluid

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2018 Audi S6, 2017 Audi S6, 2016 Audi S6, 2016 Audi S4, and 2015 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

The gear set, the manual transmission and the transfer case in the S tronic transmission 0B5 share a common transmission fluid chamber, which is checked and filled by a single plug.

NOTE:

All tightening specifications are also outlined in the "S tronic Transmission Internal Components" service information.

Fig 1: ATF Drain, Fill And Check Plugs Assembly Overview

Courtesy of AUDI OF AMERICA, LLC

ATF Drain Plug
- Tightening specification 45 Nm
Seal
- For the ATF drain plug
- Replace
Transmission Fluid (MTF) Fill and Check Plug
- Tightening specification 45 Nm
- Inside the manual transmission, front final drive and transfer case
ATF Fill and Check Plug
- Tightening specification 45 Nm
Transmission Fluid (MTF) Drain Plug
- Tightening specification 45 Nm
- Inside the manual transmission, front final drive and transfer case
- Depending on the date of manufacture, Transmission Fluid Temperature Sensor 2 -G754- may also serve as the transmission fluid drain plug; tightening specification for removing and installing. Refer to (See Figure and Figure).