Transmission Range Gear Recognition Switch -F208-, REMOVING AND INSTALLING: Installing

WARNING: This page is about a different car, the 2013 Audi S4, 2012 Audi S4, 2011 Audi S4, and 2010 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

-- Install the Transmission Range Gear Recognition Switch -F208- in the selector shaft cover. Tightening specification. Refer to TIGHTENING SPECIFICATION .

NOTE:

Ignore items -1- and -3-.

Fig 1: Attaching Bolts And For Selector Rod And Push Rod

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the bolts -arrows- on the tunnel crossmember. Tightening specification. Refer to OVERVIEW - SUBFRAME MOUNT -item 2- Bolt (See Figure).

Fig 2: Identifying Bolts & Tunnel Crossmember

Courtesy of AUDI OF AMERICA, LLC

-- Assemble the exhaust system making sure it is not under stress. Refer to OVERVIEW - MUFFLER , and EXHAUST SYSTEM, INSTALLING WITHOUT TENSION .

-- Install the rear noise insulation. Refer to OVERVIEW - NOISE INSULATION .