Overview - Transmission Housing
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2015 Audi S4, 2015 Audi A4 Quattro, and 2014 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Removing and installing the pinion is currently not possible.
- Intermediate Piece
- Replace if damaged
- Ball Stud
- 25 Nm
- Apply plenty of Grease G 000 150 to the clutch release lever bearing surface.
- Cap
- For the transmission ventilation
- Bleed Pipe
- Installed dimension; refer to Figure
- Unclip the transmission breather cap
- Shaft Seal
- For the left flange shaft
- Removing and installing. Refer to LEFT SEAL, REPLACING .
- Differential
- Replace differential tapered bearing. Refer to OVERVIEW - DIFFERENTIAL
.NOTE:
The differential bevel gears cannot be removed or installed.
- Replace differential tapered bearing. Refer to OVERVIEW - DIFFERENTIAL
.
- O-Ring
- Always replace.
- Coat with transmission fluid
- Final Drive Cover
- Replacing. Refer to FINAL DRIVE COVER, REPLACING .
- Bolt
- 20 Nm + 90° additional turn
- Steel bolts (M8; 38 mm long)
- Quantity 10
- Right Flange Shaft
- With circlip
- Removing and installing. Refer to RIGHT FLANGE SHAFT, REMOVING AND INSTALLING .
- Shaft Seal
- For the right flange shaft
- Removing and installing. Refer to RIGHT SEAL, REPLACING .
- Oil Catch Tray
- Pinion
- Cannot be replaced at this time.
- Bearing Bushing
- Ball Bearing
- Circlip
- Installed position. Refer to Figure.
- Circlip
- Installed position. Refer to Figure.
- Ball Bearing
- Magnet
- Clean off
- Drain plug
- 45 Nm
- Transmission Housing
- Cannot be replaced at this time.
- Different versions
- For some transmission a plug is installed instead of the transmission fluid heater. Refer to Figure.
- Allocate correct version.