Inspection Procedure
WARNING: This page is about a different car, the 2014 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- When using the Techstream with the vehicle power switch off, connect the Techstream to the vehicle and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the Techstream and the vehicle begins. Then select the vehicle type under manual mode and enter the following menus: Body Electrical / Smart Access. While using the Techstream, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the Techstream and the vehicle.
- The smart access system with push-button start (for Start Function) uses the LIN communication system and CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2013 - ] . Troubleshoot the smart access system with push-button start (for Start Function) after confirming that the communication systems are functioning properly.
- Inspect the fuses of circuits related to this system before performing the following inspection procedure.
- After repair, confirm that no DTCs are output by performing "DTC Output Confirmation Operation".
HINT:
RELATED DATA LIST AND ACTIVE TEST ITEMS
| DTC | Data List Item | Active Test Item |
|---|---|---|
| B2286 | Power Source Control
|
- |