DTC B2324: Rear Door LH ECU Communication Stop [08/2013 - ]: Procedure

1. Remove the instrument panel junction block assembly. Refer to REMOVAL [08/2013 - ] .

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Remove the main body ECU (multiplex network body ECU) from the instrument panel junction block assembly.
3. Measure the resistance according to the value(s) in the table below.

   HINT: 

   This inspection is to check the LIN line in the instrument panel junction block assembly that connects the wire harness to the built-in main body ECU (multiplex network body ECU).

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   3C-26 (LIN2) - MB-16 (LIN2)	Always	Below 1 Ω

   TEXT IN ILLUSTRATION
   
   

   *a

   Component without harness connected (Instrument Panel Junction Block Assembly)

   *b

   Component without harness connected (Instrument Panel Junction Block Assembly)

NG → See step   6 

OK: Go to next step 

1. Disconnect the O2 power window regulator motor assembly (for rear LH door) connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   3C-26 (LIN2) - O2-9 (LIN)	Always	Below 1 Ω
   3C-26 (LIN2) - Body ground	Always	10 kΩ or higher

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: Go to next step 

1. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   O2-2 (B) - Body ground	Power switch off	11 to 14 V

2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   O2-1 (GND) - Body ground	Always	Below 1 Ω

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: Go to next step 

1. Replace the power window regulator motor assembly (for rear LH door). Refer to REMOVAL [08/2013 - ] .

NEXT: Go to next step 

1. Clear the DTCs. Refer to DTC CHECK / CLEAR [08/2013 - ] .
2. Check for DTCs.

   OK

   DTC B2324 is not output.

NG → See step   7 

OK → END (POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Rear LH Door) WAS DEFECTIVE)