Slip Indicator Light does not Come ON [08/2013 - ]: Procedure

1. Check if CAN communication system DTCs are output. Refer to DIAGNOSIS SYSTEM [08/2013 - ] .

   Result

   Result	Proceed to
   DTCs are not output.	A
   DTCs are output.	B

B → See step   4 

A: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Select the Active Test on the Techstream. Refer to DATA LIST / ACTIVE TEST [08/2013 - ] .
   ABS/VSC/TRAC
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   Slip Indicator Light	Slip indicator light	Indicator light ON/OFF	Observe combination meter assembly

4. Check that the slip indicator light on the combination meter assembly turns on or off in accordance with Techstream operation.

   OK

   The slip indicator light turns on or off in accordance with Techstream operation.

   HINT: 

   If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing the part. Refer to PROBLEM SYMPTOMS TABLE [08/2013 - ] .

NG → See step   3 

OK → See step   5 

1. Turn the power switch off.
2. Perform the Active Test of the combination meter assembly (meter CPU) using the Techstream. Refer to DATA LIST / ACTIVE TEST [08/2013 - ] .
3. Check the combination meter assembly.

   OK

   The slip indicator light turns on or off in accordance with Techstream operation.

   HINT: 

   If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step. Refer to PROBLEM SYMPTOMS TABLE [08/2013 - ] .

NG → See step   6 

OK → See step   5