Installation [08/2013 - ]

WARNING: This page is about a different car, the 2014 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

Use the same procedure for the RH and LH sides.
The procedure described below is for the LH side.

INSTALL HEADLIGHT ASSEMBLY
1. Connect each connector.
2. Install the headlight assembly with the 3 screws and bolt.
  Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
INSTALL FRONT FENDER UPPER PROTECTOR
1. Engage the 2 guides.
2. Engage the 4 clips to install the front fender upper protector.
INSTALL FRONT BUMPER ASSEMBLY
Refer to INSTALLATION [08/2013 - ]
CONNECT CABLE TO AUXILIARY BATTERY NEGATIVE TERMINAL (for HID Headlight)
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION [08/2013 - ] .
INSTALL LUGGAGE TRIM SERVICE HOLE COVER (for HID Headlight) . Refer to INSTALLATION [08/2013 - ] - Step 3
ADJUST HEADLIGHT AIMING
Refer to ADJUSTMENT [08/2013 - ]
ADJUST FOG LIGHT AIMING
Refer to ADJUSTMENT [08/2013 - ]