DTC P0107: Manifold Absolute Pressure / Barometric Pressure Circuit Low Input; DTC P0108: Manifold Absolute Pressure / Barometric Pressure Circuit High Input [08/2013 - ]: Description

WARNING: This page is about a different car, the 2014 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.

Refer to DTC P0106. Refer to DESCRIPTION .

DTC No.	DTC Detecting Condition	Trouble Area
P0107	The output voltage from the manifold absolute pressure sensor less than 0.5 V for 0.5 seconds (1 trip detection logic).	Open or short in manifold absolute pressure sensor circuit Manifold absolute pressure sensor ECM
P0108	The output voltage from the manifold absolute pressure sensor higher than 4.5 V for 0.5 seconds (1 trip detection logic).	Open or short in manifold absolute pressure sensor circuit Manifold absolute pressure sensor ECM

HINT:

When any of these DTCs are output, check the manifold absolute pressure using the Techstream. Enter the following menus: Powertrain / Engine and ECT / Data List / Primary / MAP.

Pressure Displayed	Malfunction
Approximately 0 kPa(abs) [0 mmHg(abs)]	Short in PIM circuit to ground Short in PIM circuit to E2 circuit Open in VC circuit
130 kPa(abs) [975 mmHg(abs)] or higher	Short in VC circuit to PIM circuit Open in PIM circuit Open in E2 circuit