Precaution [08/2013 - ]
WARNING: This page is about a different car, the 2014 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.
- PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL NOTE:
When disconnecting the cable from the negative (-) auxiliary battery terminal, initialize the following systems after the cable is reconnected.
System Name See Procedure Parking Assist Monitor System Refer to INITIALIZATION [08/2013 - ] Power Trunk Lid System - WHEN DISCONNECTING AUXILIARY BATTERY CABLE
- Before disconnecting the cable from the negative (-) auxiliary battery terminal, wait for at least 60 seconds after turning the power switch off (w/ Navigation System). The HDD navigation unit stores the user settings after the power switch is turned off.
- WHEN AUTOMATIC COLLISION NOTIFICATION HAS ACTIVATED
- Perform "ACN CALL END" with Techstream to terminate ACN (Automatic Collision Notification) with the call center. Refer to ACN CALL END [08/2013 - ] .
- The BUB (Back-Up Battery) must be replaced.
- WHEN DISCONNECTING CONNECTORS FROM DCM (TELEMATICS TRANSCEIVER)
- The power switch must be off.
- WHEN REPLACING THE DCM (TELEMATICS TRANSCEIVER)
- After installing a new Telematics Data Communication Module (DCM (Telematics Transceiver)), perform "DCM ACTIVATION" with the Techstream. Refer to DCM ACTIVATION [08/2013 - ] . This allows the Telematics service provider to register the new DCM (Telematics Transceiver) and to delete the old DCM (Telematics Transceiver) information from their database.NOTE:
Do not replace the DCM (telematics transceiver) with one from another vehicle.
- After installing a new Telematics Data Communication Module (DCM (Telematics Transceiver)), perform "DCM ACTIVATION" with the Techstream. Refer to DCM ACTIVATION [08/2013 - ] . This allows the Telematics service provider to register the new DCM (Telematics Transceiver) and to delete the old DCM (Telematics Transceiver) information from their database.
- WHEN UNABLE TO CONTACT WITH CALL CENTER BUT NO DTC
- This may occur when the cellular signal strength was very weak. Check "DCM OPERATION HISTORY" with the Techstream. Refer to DCM OPERATION HISTORY [08/2013 - ] .
- WHEN DIAGNOSING DCM (TELEMATICS TRANSCEIVER)
- While attempting to diagnose the DCM (Telematics Transceiver), do not use a DCM (Telematics Transceiver) from another vehicle. Each DCM (Telematics Transceiver) is registered to a specific VIN and should not be tested in another vehicle.