LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2015 >> A4 Prestige >> Repair and Diagnosis >> External Pages >> Different car >> Section 349 (Parking Assist Monitor System (Diagnostics - Introduction)) >> Parking Assist Monitor System >> DTC Check / Clear [08/2013 - ] >> DTC Check / Clear [08/2013 - ]

DTC Check / Clear [08/2013 - ]

WARNING: This page is about a different car, the 2014 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK DTC 
    1. Connect the Techstream to the DLC3.
    2. Turn the power switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Body Electrical / Navigation System / Trouble Codes.
    5. Check for DTCs, and then write them down.
    6. Check for DTCs. Refer to DIAGNOSTIC TROUBLE CODE CHART [08/2013 - ] .
      NOTE:

      The multi-media module receiver assembly outputs DTCs for the following system. When DTCs other than those in Diagnostic Trouble Code Chart for the parking assist monitor system are output, refer to Diagnostic Trouble Code Chart for the relevant system.

      System Proceed to
      Audio and Visual System Refer to DIAGNOSTIC TROUBLE CODE CHART [08/2013 - ]
  2. CLEAR DTC 
    1. Connect the Techstream to the DLC3.
    2. Turn the power switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Body Electrical / Navigation System / Trouble Codes.
    5. Clear the DTCs.
scientia non olet · About LEMON Manuals