Installation [08/2013 - ]

WARNING: This page is about a different car, the 2014 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL BATTERY COOLING BLOWER ASSEMBLY
NOTE:
- Be sure not to touch the fan part of the battery cooling blower assembly.
- Do not lift the battery cooling blower assembly using the wire harness.
1. Install the battery cooling blower assembly to the HV battery with the 3 nuts.
  Torque: 7.5 N*m (76 kgf*cm, 66 in.*lbf)
2. Connect the connector to the battery cooling blower assembly.
INSTALL NO. 2 HYBRID BATTERY INTAKE DUCT
1. Engage the 2 claws to install the No. 2 hybrid battery intake duct to the battery cooling blower assembly.
2. Install the clip.
  NOTE:
  Ensure that the No. 2 hybrid battery intake duct is installed securely.
INSTALL NO. 2 HYBRID VEHICLE BATTERY UPPER COVER BRACKET
1. Install the No. 2 hybrid vehicle battery upper cover bracket with the 2 nuts.
  Torque: 7.5 N*m (76 kgf*cm, 66 in.*lbf)
INSTALL NO. 1 HYBRID BATTERY INTAKE DUCT
1. Install the No. 1 hybrid battery intake duct with the 3 clips.
  NOTE:
  Ensure that the No. 1 hybrid battery intake duct is installed securely.
INSTALL ROOM PARTITION PANEL INSULATOR See step 6
INSTALL REAR SEAT SIDE GARNISH LH . Refer to INSTALLATION [08/2013 - ] - Step 24
INSTALL REAR DOOR SCUFF PLATE LH . Refer to INSTALLATION [08/2013 - ] - Step 29
INSTALL REAR SEAT ASSEMBLY
Refer to INSTALLATION [08/2013 - ]
INSTALL LUGGAGE COMPARTMENT FRONT TRIM COVER . Refer to INSTALLATION [08/2013 - ] - Step 15
INSTALL LUGGAGE COMPARTMENT FLOOR MAT . Refer to INSTALLATION [08/2013 - ] - Step 20