Installation position vent sleeve

WARNING: This page does not describe the selected car, but rather 17 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Installed Location Of Breather Sleeve

Courtesy of VOLKSWAGEN UNITED STATES, INC.

The vent sleeve must protrude from the housing by 13 mm (dimension -a-) after being pressed in.

The slot in rubber valve is located longitudinally in direction of travel.