Input shaft, servicing with 7 lining discs
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2009 Audi A4, 2008 Audi A4, 2007 Audi A4, 2006 Audi A4, and 2005 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- Servicing with the incorrect number of lining discs leads to input shaft damage after bringing vehicle into operation again.
- In this case, the software in the Transmission Control Module (TCM) J217 does not match the number of lining discs.
There are two types of transmissions. They are differentiated according to transmission code :
1. Transmission with 7 lining discs serviced
These transmissions are installed in vehicles with 4-cyl. 1.9L TDI engine, 4-cyl. 2.0L TDI engine, 6-cyl. 2.5L TDI engine, 6-cyl. 3.0L MPI gasoline engine and 6-cyl. 3.2L FSI gasoline engine.
- → Input shaft with 7 lining discs, assembly overview
- → Input shaft with 7 lining discs, disassembling and assembling
2. Transmission with 6 lining discs serviced
These transmissions are installed in vehicles with all other engines.