Clutch mechanism, servicing

WARNING: This page is about a different car, the 2005 Audi A4, 2004 Audi A4, 2003 Audi A4, and 2002 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Before beginning repairs on the electrical system:

Obtain the anti-theft radio security code.

Switch the ignition off.
Disconnect the battery Ground (GND) strap.
On vehicles equipped with Audi Telematics by OnStar ® , switch-off the emergency (back-up) battery for the Telematic/Telephone Control Module prior to disconnecting vehicle battery. Refer to
- 91 - COMMUNICATION
- 91 RADIO, TELEPHONE, NAVIGATION, TRIP COMPUTER for Cabriolet
.
After reconnecting vehicle battery, re-code and check operation of anti-theft radio. Also check operation of clock and power windows according to article and/or Owner's Manual.

After reconnecting vehicle battery on vehicles equipped with Audi Telematics by OnStar ® , switch-on the emergency (back-up) battery for the Telematic/Telephone Control Module. Refer to
- 91 - COMMUNICATION
- 91 RADIO, TELEPHONE, NAVIGATION, TRIP COMPUTER for Cabriolet
.

See Caution before beginning repairs on the electrical system. Refer to Clutch mechanism, servicing

Refer to

NOTE:

Disconnect battery Ground strap with the ignition switched off.
Lubricate all bearings and contact surfaces with polycarbamide grease G 052 142 A 2.
Before working on pedal cluster, remove cover below dash panel:
Refer to
- 68 - INTERIOR EQUIPMENT
- 68 - INTERIOR EQUIPMENT for Cabriolet
Ensure that no brake fluid escapes into the footwell, plenum chamber or onto the transmission below. If this does happen, clean the affected areas thoroughly.
When performing work in the footwell, put cloths on the carpet to protect it from possible brake fluid spills.