Section 1371 (MULTIPORT Fuel Injection [CAKA,CCBA,CMUA,CGWC,CGXC,CHMB,CTUB] (Cabriolet))
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2017 Audi S5, 2016 Audi S5, 2015 Audi S5, 2014 Audi S5, and 2013 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
- 24 MULTIPORT Fuel Injection
- General Information
- Description And Operation
- Air Filter Overview
- Component Location Overview
- Engine Compartment, Right Side
- Engine Compartment, Left Side
- Component Location: Engine Control Module -J623-
- Component Location: Accelerator Pedal Position SENSORG79 / Accelerator Pedal Position Sensor 2G185
- Installed Location On Pedal Bracket
- Installed Location On The Engine
- Electrical Connectors On Left Rear Of Engine
- Installed Location On The Back Of The Engine
- Component Location: Throttle Valve Control Module -J338-
- Component Location: Control Valve Control Unit -J808-
- Camshaft Position Sensor And Exhaust Camshaft Control Valve Cylinder Bank 1 (Right)
- Camshaft Position Sensor And Exhaust Camshaft Control Valve Cylinder Bank 2 (Left)
- Component Location Under The Intake Manifold, Cylinder Bank 1 (Right)
- Component Location Under The Intake Manifold, Cylinder Bank 2 (Left)
- Reduced Oil Pressure Switch -F378- 1
- Component Location: Oil Pressure Regulation Valve -N428-
- Installation Location Intake Manifold Runner Position Sensor 2 -G512-
- Component Location Engine Coolant Temperature Sensor -G62
- Component Location On The High Pressure Pump
- Component Location: Engine Speed Sensor -G28-
- Component Location: Charge Air Pressure Sensor -G31- / Intake Manifold Temperature Sensor -G72-
- Left Electro-Hydraulic Engine Mount Solenoid Valve -N144- And Right Electro-Hydraulic Engine Mount Solenoid Valve -N145- Installation Location
- Heated Oxygen Sensor (Ho2S) Connectors (Cylinder Bank 1)
- Heated Oxygen Sensor (Ho2S) Connectors (Cylinder Bank 2)
- Component Location: Cylinder Bank 1 (Right) Heated Oxygen Sensors
- Component Location: Cylinder Bank 2 (Left) Heated Oxygen Sensors
- Component Location: Secondary Air Injection Pump Motor -V101
- Component Location: After-Run Coolant Pump -V51
- Heated Oxygen Sensors Overview
- High Pressure Pump Overview
- Lower Intake Manifold Overview
- Releasing Pressure In High Pressure Area
- Specifications
- Diagnosis And Testing
- Removal And Installation
- Air Filter
- Control Valve Control Unit -J808-
- Engine Control Module -J623-
- Fuel Injectors
- Heated Oxygen Sensor -G39-
- Heated Oxygen Sensor 2 -G108-
- High Pressure Line
- High Pressure Pump
- Lower Intake Manifold With Fuel Rail
- Oxygen Sensor 2 After Catalytic Converter -G131-
- Oxygen Sensor After Three Way Catalytic Converter -G130-
- Throttle Valve Control Module -J338-
- Special Tools