Windshield, Removing And Installing: Removing

-- Remove the windshield wiper arms. Refer to WINDSHIELD WIPER ARMS, REMOVING AND INSTALLING .

-- Remove cowl panel trim. Refer to COWL, REMOVING AND INSTALLING .

-- Remove the left center and right sun visor. Refer to OVERVIEW - SUN VISORS .

-- Remove the interior rearview mirror. Refer to INTERIOR REARVIEW MIRROR, REMOVING AND INSTALLING .

-- Remove the left and right upper A-pillar trim panels. Refer to A-PILLAR TRIM PANEL, REMOVING AND INSTALLING .

-- Unroll with the :VAS6452/1  approximately 6.5 meters of cutting wire (approximately six turns) and cut it.

-- To prevent any damage, cover the area where the awl comes out at the bottom of the body flange with adhesive tape -1-

-- Poke the awl through the adhesive bead in this area from the inside to the outside as shown.

Courtesy of AUDI OF AMERICA, LLC

-- Thread both cutting wire ends -3- into the awl -2- and pull it toward the inside.

-- Place the cutting wire all the way around under the windshield as shown.

Courtesy of AUDI OF AMERICA, LLC

-- Mount both reel devices on the inside of the windshield as shown.

Courtesy of AUDI OF AMERICA, LLC

-- Insert the cutting wire end -1- into the reel device -2-.

Courtesy of AUDI OF AMERICA, LLC

-- Tension the cutting wire and place the protective film -2- between the instrument panel and the wire.

Courtesy of AUDI OF AMERICA, LLC

-- Cut free the first section, while doing this, the wire is guided into the integrated idler roller -arrow- from the reel device.

Courtesy of AUDI OF AMERICA, LLC

-- Insert an additional guide awl -2- into the adhesive and secure it to the windshield with the suction cup to make sure that the wire runs as close to the windshield as possible.

Courtesy of AUDI OF AMERICA, LLC

-- If necessary, move the protective film -3- along with the wire and continue cutting the window glass free with the reel device -1-.

-- Move the reel device and the guide awl as shown and cut free the area on the >>A-pillar<<.

Courtesy of AUDI OF AMERICA, LLC

-- Move the reel device and guide awl approximately to the center of the window glass as shown.

-- Cut free the window glass up to approximately the center.

Courtesy of AUDI OF AMERICA, LLC

-- Use the second reel device to cut the lower section of the window glass free.

Courtesy of AUDI OF AMERICA, LLC

-- Move the reel device upward and insert the guide awl as shown.

Courtesy of AUDI OF AMERICA, LLC

-- Cut the window glass out by moving upward along the >>A-pillar<<.

Courtesy of AUDI OF AMERICA, LLC

-- Move the reel device over the center of the window glass and over the first reel device as shown, and cut the windshield completely free at the upper edge.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the windshield from the vehicle with two suction lifters.